Summer Starts Here - Save up to 70%
Trailer Wiring Harness Installation - 2005 Chevrolet Cavalier- Video
Today on our 2005 Chevy Cavalier, we'll be installing the Curt 4 pole flat trailer connector, part number C58044. To begin with, you will need to open the trunk of the vehicle. Next, you'll go ahead and locate, on the driver's and the passenger's side, there'll be one plastic nut that will help hold the carpet in place. You'll need to remove this nut from both sides. Once you pull back the carpet, it'll go ahead and expose the wires that we'll be connecting to. Next, we'll go ahead and take the trunk threshold off too. more
11/26/2014 9:53:36 AM
Trailer Wiring Harness Installation - 2003 Chevrolet Cavalier- Video
Today on our 2003 Chevy Cavalier well be installing the Draw Tite four pole wiring kit, part number 18252. First well need to remove the carpeting behind each of the taillights. To do this well remove the fastener behind each taillight and then we can pull the carpeting back. As you can see we can now access the wiring behind the taillight assembly. Note for this application it already has an aftermarket wiring setup to be towed behind an RV. However, it will not change how we make the connection with a new four pole wire, connecting to the wires on the manufacturers side of the wiring. more
11/20/2012 10:21:14 AM
Trailer Wiring Harness Installation - 2004 Chevrolet Cavalier- Video
Alright, today on this 2004 Chevrolet Cavalier, were gonna install part number 18252 which is our 4-Pole wire harness.This wire harness has to be hardwired into the car and to do that we have to get access to the wiring, which will be on the inside of the trunk. And well have to access both tail lights. Were gonna undo our tie down right here and pull back the carpet and these are the wires that well be attaching to. The yellow will be our left turn, brown will be our running light and then well use the sheet metal here for our ground. Lets go ahead and install our ground first.To wire our harness were gonna had a small ring terminal and use a self-tacking screw to go into our sheet metal. Well double check our wirings. more
2/20/2012 1:48:21 PM
Filter Videos
Filter Videos
